Air Suspension Compressor Pump For Mercedes W251 R320 R350 R500 R550 R63 AMG

Air Suspension Compressor Pump For Mercedes W251 R320 R350 R500 R550 R63 AMG

Compatibility Chart 1, You can distinguish specific model of an automobile by VIN(Vehicle Identification Number). 2, VIN(Vehicle Identification Number) consists of total 17 English letters and arabic digits. 3, VIN does not include the letters I (i), O (o), and Q (q) (to avoid confusion with numerals 1 and 0). Air Suspension Compressor Pump For Mercedes W251 R320 R350 R500 R550 R63 AMG. 1, You can distinguish specific model of an automobile by VIN(Vehicle Identification Number). Wagon 4-Door 5.5L 2008 R63 AMG Base Wagon 4-Door 6.3L 2007. Caution: Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified in the instructions or in a different sequence. To avoid the possibility of short circuits while working with electric components consult your owner’s manual on how to disconnect your battery. Consult your vehicle owner’s manual, service manual, or car dealer for the correct jacking points on your vehicle and for additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath the vehicle if it is not adequately supported, as serious injuries and death can occur. Set steering to straight ahead. Lift vehicle and remove front right wheel. Remove the fasteners and front inner wheel well liner from the vehicle to expose the vehicle’s air suspension compressor. (picture 2,3,4,5). Locate and disconnect the two(2)electrical connectors from the compressor. Locate and slowly remove the air line from the compressor. Remove the air line fitting from the air hose and discard. Locate the larger rubber hose leading to the compressor. Pinch and slide the hose clamp off of the air fitting and remove the air hose. Locate and remove the three(3)mounting nuts to remove the compressor from the vehicle. (picture 12,13,14,15). Installation is in the reverse order of air compressor removal using factory mounting hardware. When the air compressor being replaced, the matching relay must be replaced according to the corresponding vehicle. If there is something wrong with the relay which leads the compressor to continuous operation without any break, it will burn out the electric motor or other plastic part. When the air compressor being installed, the critical parts such as rubber shock pad and damping spring must be fully fixed on the stand without short installation or missing installation (The air compressor is unequipped with parts). With the anti-vibration parts of short installation or missing installation, a loud noisy instance will happen when the air compressor is working for the sake of resonance. Distribution valve, shock absorber, air tank and tube connector must be checked after air compressor installed to ensure air-tightness. The lifespan of the air compressor will be shortened if the leakage exists. Increased noises while the compressor is running may be caused by a non-functioning compressor mounting. Change the rubbers and springs of the mounting in any case. A porous intake hose often is the cause for a breakdown of the compressor. Change the intake hose and preferably also the filter and noise absorber, because we do not want the compressor to breakdown because of these. Change the relays before installing the compressor even if it seems to still work. Be sure to change the right relays. Relays look similar, that is why there is a risk to change the wrong relays. Be sure to check whether the system is leakproof after repairing. The easiest way to do this is to park the vehicle. Wait for the system to automatically re-adjust if your car has this feature. Then measure the heights from the ground to the lower edge of the fender as exactly as possible and take notes. On the day after measure these heights again and compare them with the ones before. Even a small difference will lead to a damaged compressor and damaged valves in the long run. 2513201204,2513201304,2513202004, 2513202104,2513202704,2513202604. Single Dimension(CM) 31.75(length)17.78(width)17.78(height). Front Engine RWD & 4WD. Air Suspension Compressor Pump. OE Spec or Performance/Custom. 30 Days Free Return. International Buyers C Please Note. These charges are the buyers responsibility. Q: How do I return an item? Please contact our customer service before you return an item. If you are dissatisfied for any reason, please do not be quick to leave negative/neutral feedback. H4 HB2 Halogen Bulb 9003 HID 100W High Low Beam Headlight White Light 5900K. Glossy Black / Clear Lamps Assembly Taillights For 07-13 Chevy Suburban Tahoe. For 02-06 Dodge Ram 35Pack Dashboard Gauge Cluster Light Bulbs LED Set White. 2018 Power Cree LED Headlight Kit 9006 9012 6400W 6000K 640000LM Pair HID Lamps. UTV & ATV Brake System Parts. Kevlar Carbon Brake Pads. Cylinder Head Gasket Sets. Brake Pads & Rotors. Brake Rotors and Pads. Nerf Bars & Running Boards. Cylinder Piston Gasket Sets. Specific LED Package Kit. Electrical & Test Equipment. AC Condenser & Radiator. Mass Air Flow Sensor. ABS Wheel Speed Sensor. 120W 12800lm 4 Sides LED Headlight Kit H4 HB2 9003 Hi/low beams HID 6000K Bulbs. 2pcs 3157 White 6000K Back Up Reverse Projector +12-SMD Chip LED Lights Bulbs. The item “Air Suspension Compressor Pump For Mercedes W251 R320 R350 R500 R550 R63 AMG” is in sale since Friday, August 24, 2018. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Shocks & Struts”. The seller is “cn-batteries” and is located in Ontario, California. This item can be shipped to United States.

• Placement on Vehicle: Left
• Size: Single Dimension(CM) 31.75(length)*17.78(width)*17.78(height)
• Single Weight(KG): 4.300
• Included Hardware: None
• Certification: ISO9001
• Lubrication Style: Oil-Free
• Drive Layout: Front Engine RWD & 4WD
• Platform: W251
• Material: Iron
• Color: Silver
• Product Type: Air Suspension Compressor Pump
• Model: Airmatic
• OE Spec or Performance/Custom: OE Spec
• Warranty: 1 Year
• Fitment Type: Direct Replacement
• Greasable or Sealed: Sealed
• Adjustable: No
• Return Policy: 30 Days Free Return
• Bundle Listing: Single
• Brand: cn-batteries
• UPC: Does not apply
• Manufacturer Part Number: CB110098S01
• Interchange Part Number: 2513200604, 2513202604, 2513202704
• Other Part Number: 17533007547, 17533008066, 17533008547
• Superseded Part Number: 2513200804