Air Suspension Compressor Pump For Porsche Cayenne Turbo GTS 2002-2010

Air Suspension Compressor Pump For Porsche Cayenne Turbo GTS 2002-2010

Compatibility Chart 1, You can distinguish specific model of an automobile by VIN(Vehicle Identification Number). 2, VIN(Vehicle Identification Number) consists of total 17 English letters and arabic digits. 3, VIN does not include the letters I (i), O (o), and Q (q) (to avoid confusion with numerals 1 and 0). 1, You can distinguish specific model of an automobile by VIN(Vehicle Identification Number). Front Engine-Four Wheel Drive Layout. Caution: Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified in the instructions or in a different sequence. To avoid the possibility of short circuits while working with electric components consult your owner’s manual on how to disconnect your battery. Consult your vehicle owner’s manual, service manual, or car dealer for the correct jacking points on your vehicle and for additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath the vehicle if it is not adequately supported, as serious injuries and death can occur. Set the steering to straight ahead. Remove protective shroud on the right side to access the compressor. Remove the two(2)cable ties holding the connector wires. Disconnect the three(3)electrical connectors to the compressor. Remove the compressor air line(runs between the compressor and dryer). Remove the air line fitting from the air hose and discard. Disconnect the lines from the air valve blockblack line(p)does not have to be disconnected. Note:Your compressor may not have a brown line as shown in picture e. If the brown line is not present, just disconnect the other(4)lines indicated and proceed to the next step. Remove the three(3)mounting bolts that secure the compressor to the vehicle. Disconnect the brown line(located on backside of compressor). Compressor can be removed from the vehicle. Note:If a brown line is not present on your compressor then this step can be omitted. Disconnect the line from the compressor dryer(identified as “p” On the air valve block)(does not need to be disconnected at air valve block). Remove the 2 nuts from the backside of the mounting bracket, remove bracket. Remove the thermal sensor wire harness by disconnecting the connector, loosening the sensor screw and removing the sensor. (this will be re-installed in the new compressor). Remove the three(3)mounting isolators from the compressorthese will be re-used on the new compressor. If the isolators are damaged it is recommended that they be replaced(contact your dealer for replacements). Installation is in reverse order of air spring removal, with the exception of the Secured reservoir hose. When the air compressor being replaced, the matching relay must be replaced according to the corresponding vehicle. If there is something wrong with the relay which leads the compressor to continuous operation without any break, it will burn out the electric motor or other plastic part. When the air compressor being installed, the critical parts such as rubber shock pad and damping spring must be fully fixed on the stand without short installation or missing installation (The air compressor is unequipped with parts). With the anti-vibration parts of short installation or missing installation, a loud noisy instance will happen when the air compressor is working for the sake of resonance. Distribution valve, shock absorber, air tank and tube connector must be checked after air compressor installed to ensure air-tightness. The lifespan of the air compressor will be shortened if the leakage exists. Increased noises while the compressor is running may be caused by a non-functioning compressor mounting. Change the rubbers and springs of the mounting in any case. A porous intake hose often is the cause for a breakdown of the compressor. Change the intake hose and preferably also the filter and noise absorber, because we do not want the compressor to breakdown because of these. Change the relays before installing the compressor even if it seems to still work. Be sure to change the right relays. Relays look similar, that is why there is a risk to change the wrong relays. Be sure to check whether the system is leakproof after repairing. The easiest way to do this is to park the vehicle. Wait for the system to automatically re-adjust if your car has this feature. Then measure the heights from the ground to the lower edge of the fender as exactly as possible and take notes. On the day after measure these heights again and compare them with the ones before. Even a small difference will lead to a damaged compressor and damaged valves in the long run. 95535890101,95535890102, 95535890103,95535890104, 95535890105. Single Dimension(CM) 32.00(length)18.00(width)18.00(height). 30 Days Free Return. OE Spec or Performance/Custom. International Buyers C Please Note. These charges are the buyers responsibility. Q: How do I return an item? Please contact our customer service before you return an item. We will work hard to make sure EVERY CUSTOMER 100% SATISFIED and resolve any problem for you and always leave a feedback to all our customers. If you are satisfied with the product you received, wish you can leave us a feedback. Fuel Efficiency Trunk Wing Spoiler Fits For 16-Up Honda Civic Hatchback Increase. Rear Slotted Brake Rotors + Ceramic Pads fits Chrysler PT Cruiser 2004 – 2010. 4pc Front &Rear Stabilizer Sway Bar End Links for 2005 – 2006 PONTIAC MONTANA. 1PC Lower Front Control Arm Fits Dodge Grand Caravan 2001 – 2004 2005 2006 2007. UTV & ATV Brake System Parts. Kevlar Carbon Brake Pads. Cylinder Head Gasket Sets. Brake Pads & Rotors. Brake Rotors and Pads. Brake Drum & Shoe. Nerf Bars & Running Boards. Cylinder Piston Gasket Kit. Specific LED Package Kit. Electrical & Test Equipment. AC Condenser & Radiator. Mass Air Flow Sensor. ATV Rear Wheel Axle. ABS Wheel Speed Sensor. Idle air control valve. Transfer Case Shift Motor. Secondary Air Injection Pump. Spark Plug Ignition Wire. Air Cleaner Filter Box. Cold Air Intake Kit. Oil Catch Can Tank. Air suspension valves solenoid. Fuel Shut Off Solenoid. ATV Brake Master Cylinder. Rotary Vane Vacuum Pump. Throttle Cable Carb Bracket. Oil Fuel Hose Line. LED 3RD Brake Light. Wheel Stem Air Valve Cap. Splash Guards & Mud Flaps. Light Bar Mount Bracket. Other Golf Cart Parts. 4 pcs wheel hub bearing. Tire Inflator Air Pump. Brake Line Lock Kit. Other Handlebars & Levers. 2pc 3157 4114 4157 LED DRL Driving Daytime Running Light Bulbs 12SMD 6000K White. For Chevy Silverado GMC Sierra 1500 2500 3500 1999-04 Fuel Pump Module Assembly. Fuel Pump for Chevy S10 GMC Sonoma Hombre 4.3L 97-02 for Isuzu Hombre 4.3L 97-20. Low Pressure Electric Fuel Pump 12V Gas Diesel Inline HEP-02A BHEP-02A. 2 Bulbs H4 HB2 9003 LED Headlight Kit Combo 2600W 390000LM High Low Beam 6000K. The item “Air Suspension Compressor Pump For Porsche Cayenne Turbo GTS 2002-2010″ is in sale since Thursday, November 30, 2017. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Shocks & Struts”. The seller is “cn-batteries” and is located in Ontario, California. This item can be shipped to United States.

• Placement on Vehicle: Left
• Size: Single Dimension(CM) 32.00(length)*18.00(width)*18.00(height)
• Single Weight(KG): 4.640
• Included Hardware: Compressor
• Certification: ISO9001
• Lubrication Style: Oil-Free
• Drive Layout: Front Engine 4WD
• Platform: MLB
• Material: Iron
• Color: Silver
• Part Type: Air Suspension Compressor
• Custom Bundle: No
• Return Policy: 30 Days Free Return
• Warranty: 1 Year
• Quantity: Single
• Fitment Type: Direct Replacement
• OE Spec or Performance/Custom: OE Spec
• Adjustable: Yes
• Greasable or Sealed: Sealed
• Brand: cn-batteries
• UPC: 688209040111
• Manufacturer Part Number: CB110547S01
• Interchange Part Number: 95535890105, 95535890103, 95535890104
• Other Part Number: 95535890100, 95535890101, 95535890102