OE-Spec Air Ride Suspension Compressor Pump 15254590 for Escalade Tahoe Yukon US
OE-Spec Air Ride Suspension Compressor Pump 15254590 for Escalade Tahoe Yukon US
An Air Ride Suspension Compressor Pump is a vital component in a vehicle’s air suspension system. It supplies compressed air to the air springs, supporting the vehicle’s weight and providing a smooth ride? GET THE RIGHT PART — Before purchasing, please check the. To ensure this part will fit your vehicle; enter all vehicle information (year, make, model, engine and trim) for compatibility and check qualifier notes. Reference OEM Parts Number:15254590, 19299540, 949-000, 949-001,19299545, 15101577, 15070878, 15056494, 10395825, 20930288, 22941806. More safer and smoothier: supporting the vehicle’s weight and providing a smooth ride? Provides a direct replacement with no modifications needed. What you get:(1)Air Ride Suspension Compressor Pump and 7/24 world-class customer care services. (1) Air Ride Suspension Compressor Pump. INSTALLING AIR RIDE SUSPENTION COMPRESSOR: A STEP-BY-STEP GUIDE. Tools needed:13mm Socket, 24mm Wrench, Socket Extensions, Rust Penetrant, Jack Stands, Ratchet, Floor Jack, Trim Tool Set, T25 Torx Driver. Step 1 :Removing the Air Suspension Pump, Raise the vehicle with a jack, Secure the vehicle on jack stands, Remove the 13mm bolt from the frame, Pry the pick-up filter from the wire clip, Maneuver the pick-up filter free, Remove the 13mm bolt in the frame, Loosen the 13mm bolt from the compressor bracket, Lower the compressor off, Disconnect the connectors from the pump. Step 2 :Preparing the New Pump, Pry the clips out from the cover, Remove the cover from the bracket and old compressor, Remove the T25 Torx bolts from the bracket, Pry the old airlines out of the clips on the bracket, Remove the pump from the bracket, Remove the old air connector hose, Slide the connector hose onto the new compressor, Remove the plastic band from the new connector, Place the pump into the bracket, Tighten the T25 Torx bolts to the bracket, Press the cover onto the bracket, Place on the new pressure sensor and locking washer with a 24mm wrench, Connect the electrical connector to the pressure sensor. Step 3 :Installing the Air Suspension Pump, Slide the two studs into the holes in the frame, Tighten the 13mm bolt into the frame, Insert the pick-up filter into place and clip it in, Connect the connectors to the pump.