https://windcompressorpumps.com Mon, 17 Aug 2026 21:06:46 +0000 en-CA hourly 1 https://wordpress.org/?v=4.1.1 https://windcompressorpumps.com/2024/03/11/4500psi-30mpa-electric-high-pressure-air-compressor-pump-with-pipes-water-cooled/ https://windcompressorpumps.com/2024/03/11/4500psi-30mpa-electric-high-pressure-air-compressor-pump-with-pipes-water-cooled/#comments Mon, 11 Mar 2024 17:04:08 +0000 https://windcompressorpumps.com/2024/03/11/4500psi-30mpa-electric-high-pressure-air-compressor-pump-with-pipes-water-cooled/ Read More]]>





















4500psi 30mpa Electric High Pressure Air Compressor Pump With Pipes Water Cooled. 30mpa 4500psi Electric High Pressure Air Compressor Scuba Diving Pump with Pipes. The Oil-water Filter Is Bigger and the Filtering Effect Is Better. Directly Inflate the Diving Cylinder Without Air Filter. Water-cooled Submersible Breathing High-peable Diving Cylinder, with Activated Carbon Filter, Pure Output. 110v Electric Air Compressor Diving Pump 30mpa. Rated Power:1.8kw. Motor Speed: 2800r / Min. Air Output: 130l / Min. Cooling Mode: Water Cooling. Compression Level: Secondary Compression. Lubrication Method: Splash Type. Motor Material: All Copper Coil. Cylinder Head Material: Cast Aluminum. Working Pressure: 0-30mpa (4500psi). Maximum Temperature: 80? Connector Type: 8mm Quick Connect Female. Package Size: 49 28.5 43cm. Total Weight: 20.5kgs. Oil: Add Piston Type Air Compressor Oil (the Machine Has No Oil, Because It Is Not Allowed to Carry Oil by Air). Speed Test: It Takes 3 Minutes for 0.5l Oxygen Cylinder to Inflate 30mpa, 6 Minutes for 1l Oxygen Cylinder to Inflate 30mpa, and 40 Minutes for 6.8l Oxygen Cylinder to Inflate 30mpa. Operation Method of Electric Air Pump. Check the Amount of Oil Before Each Use, the Oil Should Exceed the Red Dot, but Not Too Much. The Lubricating Oil That Is Exported to Foreign Countries Is Taken out and Needs to Be Added by Itself. Replace the Breathing Plug. Change the Oil Cover Used for Transportation to a Strip-shaped Breathing Plug. Loosen the Air Bleed Screws on Both Sides Before Starting the MachineRemember, the Machine Needs to Start Under Zero Pressure. If the Bleeder Screw Is Not Loosened, the Machine Will Not Start. After Starting the Machine, Tighten the Bleed Screws on Both Sides to Press Normally After the End of the Inflation, Loosen the Deflated Screw and Then Deflate, Then Take the Inflation Joint. To Install the Water Pump, You Need to Put the Water Pump into the Water. The More Cold Water, the Better. After the Water Pump Is Normally Circulated, the Electric Air Pump Can Be Turned on Manually Shut down After Reaching the Required Pressure, the Whole Process Needs Attention, and It Is Forbidden to Leave. 1 X Set of 30mpa High Pressure Air Pump. 1 X Water Pump. 2 X Water Pipes. 1 X Spring Hose. 2 X Pressure Relief Screws. 1 X Tank Breather Plug. 1 X Shock Pad. 1 X This Manual. If you have any questions, please feel relax to contact with us. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it’s non-workdays, please kindly be patient and wait till Monday.

]]> https://windcompressorpumps.com/2024/03/11/4500psi-30mpa-electric-high-pressure-air-compressor-pump-with-pipes-water-cooled/feed/ 0 https://windcompressorpumps.com/2024/02/18/electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes-4500psi-30mpa/ https://windcompressorpumps.com/2024/02/18/electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes-4500psi-30mpa/#comments Mon, 19 Feb 2024 03:45:42 +0000 https://windcompressorpumps.com/2024/02/18/electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes-4500psi-30mpa/ Read More]]>














Electric High Pressure Air Compressor Scuba Diving Pump with Pipes 4500PSI 30MPa. 4500PSI High Pressure Electric Air Compressor Scuba Diving Pump Water Cooling. The oil-water filter is bigger and the filtering effect is better. Directly inflate the diving cylinder without air filter. Water-cooled submersible breathing high-peable diving cylinder, with activated carbon filter, pure output. 110V Electric Air Compressor Diving Pump 30MPA. Rated power:1.8kw. Motor speed: 2800r / min. Air output: 130L / min. Cooling mode: water cooling. Compression level: secondary compression. Lubrication method: splash type. Motor material: all copper coil. Cylinder head material: cast aluminum. Working pressure: 0-30mpa (4500psi). Maximum temperature: 80? Connector type: 8mm quick connect female. Package size: 49 28.5 43cm. Total weight: 20.5kgs. Oil: add piston type air compressor oil (the machine has no oil, because it is not allowed to carry oil by air). Speed test: it takes 3 minutes for 0.5L oxygen cylinder to inflate 30MPa, 6 minutes for 1L oxygen cylinder to inflate 30MPa, and 40 minutes for 6.8L oxygen cylinder to inflate 30MPa. Operation Method of Electric Air Pump. Check the amount of oil before each use, the oil should exceed the red dot, but not too much. The Lubricating oil that is exported to foreign countries is taken out and needs to be added by itself. Replace the breathing plug. Change the oil cover used for transportation to a strip-shaped breathing plug. Loosen the air bleed screws on both sides before starting the machineRemember, the machine needs to start under zero pressure. If the bleeder screw is not loosened, the machine will not start. After starting the machine, tighten the bleed screws on both sides to press normally After the end of the inflation, loosen the deflated screw and then deflate, then take the inflation joint. To install the water pump, you need to put the water pump into the water. The more cold water, the better. After the water pump is normally circulated, the electric air pump can be turned on Manually shut down after reaching the required pressure, the whole process needs attention, and it is forbidden to leave. 1 x set of 30MPa high pressure air pump. 1 x water pump. 2 x water pipes. 1 x spring hose. 2 x pressure relief screws. 1 x tank breather plug. 1 x shock pad. 1 x This manual. If you have any questions, please feel relax to contact with us. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it’s non-workdays, please kindly be patient and wait till Monday. 8mm quick connect female. 49 28.5 43cm.

]]> https://windcompressorpumps.com/2024/02/18/electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes-4500psi-30mpa/feed/ 0 https://windcompressorpumps.com/2024/01/24/4500psi-30mpa-electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes/ https://windcompressorpumps.com/2024/01/24/4500psi-30mpa-electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes/#comments Wed, 24 Jan 2024 14:20:52 +0000 https://windcompressorpumps.com/2024/01/24/4500psi-30mpa-electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes/





















Speed test: it takes 3 minutes for 0.5L oxygen cylinder to inflate 30MPa, 6 minutes for 1L oxygen cylinder to inflate 30MPa, and 40 minutes for 6.8L oxygen cylinder to inflate 30MPa. 110V Electric Air Compressor Diving Pump 30MPA.

]]> https://windcompressorpumps.com/2024/01/24/4500psi-30mpa-electric-high-pressure-air-compressor-scuba-diving-pump-with-pipes/feed/ 0 https://windcompressorpumps.com/2021/05/21/air-suspension-compressor-pump-fits-land-rover-discovery-3-hitachi-inc-pipes/ https://windcompressorpumps.com/2021/05/21/air-suspension-compressor-pump-fits-land-rover-discovery-3-hitachi-inc-pipes/#comments Sat, 22 May 2021 03:46:50 +0000 http://windcompressorpumps.com/2021/05/21/air-suspension-compressor-pump-fits-land-rover-discovery-3-hitachi-inc-pipes/ Read More]]>







Land Rover Discovery 3 Hitachi Air Suspension Compressor with pipe fitting kit. The lasting cure to the Amber light suspension issue. No Need for modifications. OEM Part Number: LR023964. LR045254 / RQB500491 / YWB101300 / YWB101300. Fitment: LandRover Discovery 3. Kit contents: 1 Air suspension Compressor with relay and fitting pipes. Condition: New OEM Quality replacement part. Robust design for all the various forms of land Rover Use. Olive type Airline Connectors means no leaks after fitting. Improved design features which provide a quieter, more efficient operation. Rigorously tested design using real life Land Rover owners and scenarios. This item is a direct replacement for the Hitachi type compressor. It will fit Discovery 3/4 and Range Rover Sport models. This unit will not require a software update UNLESS your vehicle has been fitted with the AMK type pump. If you are unsure of the fitment then please call our team and they will be happy to help. The item “Air suspension compressor pump fits LAND ROVER DISCOVERY 3 Hitachi -Inc pipes” is in sale since Thursday, August 13, 2020. This item is in the category “Vehicle Parts & Accessories\Car Parts\Suspension & Steering\Air Suspension & Parts”. The seller is “mainline_automotive_uk” and is located in Nottingham. This item can be shipped worldwide.

• Custom Bundle: No
• Modified Item: No
• Unit Type: Unit
• Reference OE/OEM Number: LR023964
• Placement on Vehicle: Rear
• Classic Car Part: No
• Unit Quantity: 1
• Manufacturer Part Number: Does Not Apply
• Brand: Mainline

]]> https://windcompressorpumps.com/2021/05/21/air-suspension-compressor-pump-fits-land-rover-discovery-3-hitachi-inc-pipes/feed/ 0 https://windcompressorpumps.com/2018/06/29/kbdp-exhaust-up-pipes-manifolds-to-turbo-6-6l-duramax-chevy-gmc-2001-16-lb7-lml/ https://windcompressorpumps.com/2018/06/29/kbdp-exhaust-up-pipes-manifolds-to-turbo-6-6l-duramax-chevy-gmc-2001-16-lb7-lml/#comments Fri, 29 Jun 2018 06:28:54 +0000 http://windcompressorpumps.com/2018/06/29/kbdp-exhaust-up-pipes-manifolds-to-turbo-6-6l-duramax-chevy-gmc-2001-16-lb7-lml/ Read More]]>







Stainless Mandrel Bent Tubes. High Temperature Ceramic Coating. Passenger Side Up Pipe. Drivers Side Up Pipe. It is not for sale or use in CARRB regulated areas. This product cannot be used on highway registered vehicles. By purchasing this product you agree to use it in conform to local, state, and federal laws. The purchaser of this product is responsible for. (LB7 Non-EGR engines exempt). The item “KBDP Exhaust Up Pipes Manifolds to Turbo 6.6l Duramax Chevy GMC 2001-16 LB7-LML” is in sale since Thursday, April 26, 2018. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Exhaust\Exhaust Manifolds & Headers”. The seller is “kb_diesel_performance_llc” and is located in Petersburg, Pennsylvania. This item can be shipped worldwide.

• Manufacturer Part Number: KBDP-6.6l-TUPK
• Brand: KB Diesel Performance LLC
• Interchange Part Number: 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010
• Warranty: Lifetime
• Country/Region of Manufacture: United States

]]> https://windcompressorpumps.com/2018/06/29/kbdp-exhaust-up-pipes-manifolds-to-turbo-6-6l-duramax-chevy-gmc-2001-16-lb7-lml/feed/ 0